Connector Header Surface Mount Right Angle

What type of device would you connect a Molex cable to?

The most commonly used method for Electronic connectors is twisted connection. When connecting, the insulation layer of the cable needs to be peeled off for a certain distance, and then the two cables that need to be connected are directly mixed together tightly. Cross the core ends of the cable, and then wind them for 2~3 turns. Then straighten the ends of the wires. Tightly wrap each end of the wire with another wire. After about 5 turns, remove the excess end of the wire. Because the cable is relatively thick, for this kind of large cross-section cable, we can first overlap the cores of the wires and then fill in one of the cores. Then choose another cable, wind the copper wire on it, then fold back the Cable Connectors I/O Connectors that is connected to the wire, wind the cables at both ends a few times, and finally remove the excess wire ends.

3. The third method is to straighten the core of the stripped insulation layer, and then twist it close to the insulation Heavy copper board layer and tighten it. Combine the remaining wires into an umbrella shape. After unraveling, the other cable must be treated in the same way. Then the two scattered cores are inserted into each other. Finally, each side of the wire is divided into three groups and wound one by one.