Host size: 120*88*38MM
Board size: about 6.8*3*3.3CM, including encoder and buzzer height
Display size: 1.3 inch OLED
Voltage and current: 19 to 24V recommended, current above 3A
Heating core support: T12 iron tip
Temperature range: 150 to 500 degrees (recommended range between 300 and 380)
Sleep time: 1 to 255 minutes (recommended range of 5 to 20 minutes)
Sleep temperature: 100 to 445 degrees (recommended range of 100 to 200 degrees)
Encoder stepping: 1 to 99 (recommended range 1 to 10)
Language selection: Chinese, English, Russian, Korean
Calibration parameters: 0.1 to 2.55 (the smaller the value, the higher the temperature, otherwise the higher the value, the higher the temperature, generally between 0.6 and 1.0 after calibration)
Shutdown time: 1 to 255 minutes (recommended range of 5 to 20 minutes)
Sample wait time: It is set at the factory and does not need to be set again.
T12 frequency: It is set at the factory and does not need to be set again.
Factory reset: return to factory state
One-button strong temperature value: you can set your own strong temperature value, the default is twenty degrees
One-button strong temperature time: You can set the number of seconds of strong temperature, the default is five seconds.
PW power display: calculate the current power value
Date display: support
Clock display: support
Buzzer switch: support
Low voltage protection: mainly for battery protection settings, free to set
Room temperature detection: detecting room temperature, so that the temperature is accurate, the welding temperature is good.
If your soldering station is not heated, make sure the tip or handle is well installed.
If the check handle or tip is installed properly. but soldering station still shows ERROR.
Please check the following parameters:
Soldering iron tip Select core, please choose T12.
T12 correct value is set to 0.8.
T12 frequency is set to 4.
