Why Choose Us
*Highest Sales Volume On All Platforms
*Rave reviews
*Quality assurance
*Quality service
*Ship in 48 hours (working day)
Kindly note, our remote is the COMPATIBLE / REPLACEMENT /CLONE remote , not the original one .
please make sure your remote / system can be used before buying .
As a general guide, if the remote you currently use is one of the remotes pictured in the ad then this remote will be compatible with your motor.
if you are not so sure , please contact us without hesitate
Description:
1.Type of programming: Programming with the receiver
2.Number of channels: 4
3. Code: rolling code
4. Frequency: 433.92MHz
5.Woring Range: 10-150 m (open space)
6.Power supply: 12V 27A
7.Remote come with Battery !!!
Security of use: dynamic code provides a high level of security, non-copyable code.
Disclaimer:Your Old remote must be same as the advertisement , new remote do not compatible with other remotes
Compatible Model
All DOORHAN remote control 433mhz rolling code
For example:
Doorhan Transmitter 2
Doorhan Transmitter 4
Doorhan Transmitter 2-pro
Doorhan Transmitter 4-pro
Premium RC black 4
kindly note , our remote is the COMPATIBLE / REPLACEMENT /CLONE remote , not the original one.
Programming / Learning Instructions
Program to Gate / Garage Door Openers the same way as original DOORHAN Transmitter 4 remotes, please refer to your receiver's user manual. For a typical DOORHAN Garage Control Panel, the programming procedure is as follows:
1. Press and release the button R on the receiver.
2. The left side of display panel will show 0 then disappears immediately.
3. Press any button twice, coding is completed.
4. Press the transmitter button to test operation.
Note: To remove a single transmitter's code or all transmitter codes from the receiver memory please refer to your receiver manual.
Delete All Codes（Reset the remote）
1. Turn on the power to DHRE-2 receiver unit.
2. Press CODE button for 10 seconds CODE1 (or SW1) - if you are using CH1, CODE2 (or SW2) - if you are using CH2.
3. LED1 will be flashing 10 seconds then switch off for 2 seconds and flash twice to confirm that the memory is clear.
4. Release the button. All the stored codes including the courtesy light codes should now be deleted. Confirm this by pressing the transmitters previously used to operate the device. There should be no response.
