FSH-2A homogenizer, emulsifier, high-speed disperser, laboratory adjustable high-speed homogenizer, masher

Product Specification

FSH-2A adjustable high speed homogenizer This instrument uses a silicon controlled high-speed adjustment system, and the speed measurement system uses Hall elements with advanced electronic circuits. The digital display is clear and easy to use. the first. Features of FSH-2A adjustable high-speed homogenizer: 1. Adopt internal suction homogenization structure (internal cutting tool), high speed. It can efficiently homogenize and emulsify two or more immiscible liquids, and can extract trace organic compounds, fat-soluble substances and organic solvent soluble substances in water. 2. It can achieve the purpose of homogenization and mixing for various animal and plant tissues. 3. It can rupture the cell membrane to separation, and can break DNA strands into small molecules at different speeds. 4. It can be used for micro-stirring at low speed, the speed is digitally displayed, and the reading is intuitive. second. Technical parameters of FSH-2A adjustable high-speed homogenizer: 1. Power supply: 220V 50HZ 2. Motor speed: 22000 rpm without load Large homogenization knife: 8000-18000 rpm Small homogenization knife: 8000-20000 rpm) 2. Motor power: 200W, continuous working time ≤ 5 minutes 3. Power source: AC220V 50HZ 4. Instrument weight: 8Kg third. Precautions for the use of FSH-2A adjustable high-speed homogenizer: The instrument should be placed on a horizontal work surface, and the homogenization knives required for installation must be in place. When the power is turned on and the machine is tested, first use a cup or vessel filled with water to submerge the knife head in water (must be submerged until the first Under the nozzle), turn on the power switch, slowly adjust the speed knob from slow to fast, there is no obvious metal friction sound (if there is metal friction sound, please turn off the power, loosen the tool m6 Torx screw, and turn the tool outer fixing sleeve randomly upward Install it in place, and then tighten it) before it can work. Cut the plants or microorganisms to be tested into small pieces or small pieces (the recommended particle size is about 2mm), put them in the supplied glassware, clamp them in the middle of the magnet bracket (7-shaped), and loosen the m8 Torx screws that fix the motor base. Slowly align the mouth of the vessel and move it down so that the homogenizer head is 2-3mm away from the bottom of the vessel, and then tighten the m8 Torx screws to start working. fourth. Instrument maintenance After long-term use, the PTFE in the high-speed disperser cutter is a vulnerable part for users to replace. Note: Please use steam, clean water or alcohol to rinse and dry after removing the knives after each work.