Pin definition
1.CS: chip select (floating or high, boot; low, off)
2.INR: Right channel audio signal input positive
3.AGND: audio signal input common ground
4.INL: left channel audio signal input positive
5.GND: power ground
6.VCC: sound power positive
7.SPL +: left channel output positive, then horn +
8.SPL-: left channel output negative, then speaker -
9.SPR +: right channel output positive, then horn +
10.SPR-: Right channel output negative, then speaker -
Other
- Power amplifier board, then the horn between the two pads DC voltage 0V, between the speaker pad and GND DC voltage is half of the power supply voltage.
- Use 4 oh speakers, the maximum power supply voltage can not exceed 16V, otherwise the chip is too high heat damage to the amplifier. Use 8 ohm speakers, the maximum power supply voltage can not exceed 24V, otherwise the voltage is too high breakdown power amplifier chip.
- Speaker wiring as far as possible with the control of the sound line within 3 meters, the line is too long load inductance increases and produce self-inductance voltage is too high breakdown power amplifier chip, long-term speaker recommended to consider the diode (IN5819) to achieve self-induced voltage release Protect the chip.