SHAHE LX-A-1 Shore Hardness Durometer Hardness Tester steel Gauge Measuring for Hardness portable durometer-hardness-tester

1. Type A: applicable to general rubber, synthetic rubber, vulcanized rubber, soft rubber, leather, wax, etc.

2. Type C: applicable to the hardness test of rubber microporous material.

3. Type D: applicable to hard rubber, hard resin, acrylic, glass, cushiony plastic cement, printing plates, fiber, etc

    Shaw rubber hardness gauge is an apparatus to measure vulcanized rubber and plastic products. This apparatus has three models of Type A, Type C and Type D, and each model is subdivided into two types of single pointer and double pointer.

    Type A and D respectively are applicable to the testing of low and medium hardness, and high-hardness materials.
 

    Type C applies to the testing of microporous material which is used to make shoes, with compression rate 50 percent, stress 0.049 MPa or above, and this kind of material is made of rubber plastic and has blister in plastic.This hardness gauge conforms to the regulations of GB/T531-99, GB2411-80, hg/t2489-93, JJG304-2003.

   ^{Before using, check whether the pointer of the hardness gauge points at zero position in a free state (if the point deviates}

^{from the zero position slightly, one can loosen the clamping screw at the upper right corner, rotate the gauge plate to make}

^{the pointer direct just against the zero position).}

    ^{Place the hardness gauge on glass plate, and the pointer should direct at a 100 degree angle (the end of pressure}

^{needle and the bottom surface of pressure foot should be closely in contact with the glass surface) If the pointer doesn’t}

^{point to the zero position or at a 100 degree angle, one can activate the pressure needle for several times, and if the pointer}

^{still doesn’t point to the zero position or at a 100 degree angle, it can not be used. If the hardness gauge is used on the shelf}

^{of fixed weight, one can lift the hand grip in order to make the pressure needle pressed to a full extent and contact the}

^{testing board completely under the action of gravity of weights. If at that moment the pointer directs at a 100±1 degree angle, it cannot be used, either. It’s better to send it back to the factory for adjustment.}

    ^{When one holds D type hardness gauge to check zero position or place it on the shelf of fixed burden to readjust the}

^{pointer to zero position, one should put special block under the pressure foot of hardness gauge, otherwise the pressure}

^{head of hardness gauge will damage the glass board, and moreover it is hard to show the correct value. For the specific}

^{operating method of block, one could refer to the special instruction manual.}

• 1 x LX-A-1 Shore hardness tester
• 1 x User Manual
• 1 x Packing case

    If you make a order, we will send the products to you at once after the payment is received

    If you choose is china post registered air mail, most of  the countries within 15-60 business days received.

    If you do not receive the goods within the specified time or the product is out of order, you can contact us, we will reply you within 1-2 business days and help you solve the problem, if it is our responsibility, we will re-delivery or refund

    Since your feedback is very important. If you are satisfied with our products, please give us positive feedback and 5 STARS praiseIf. Thank you. 

   If you have any problem about the item, we request that you contact us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns.

      Happy Shopping!  Thank you for your support and trust ！