Suspension TTCR-II FOR Mitsubishi Lancer Balance Bar Before The Top Bar Body Reinforcement Rod Stabilizer Bar Modified Pieces

Applicable models: for Mitsubishi Lancer Lioncel V3 Lingyue 2006-2019
Installation position D: distinguish the engine, the transmitter is different, the product is different
4A91 engine is new style /reference year 2012-2019
4G15 engine is old model /reference year 2006-2011
The year is not very accurate, it is sold globally, and the engine should be installed. If you don't understand, contact customer service


Installation location
A top bar
Top it after B
C front lower derrick
D four-point pull rod
E Zhongxiajingzi
Rear pull rod A
Rear pull rod B
Rear pull rod C
Set of 8
TCR-II8 parts of the body to strengthen the installation instructions:
Top bar after the top of it before derrick structure after rod before A after B after C middle rod rod derrick Lioncel full set of 8 pieces

1:Top bar installation:

Former top, design is located in the vehicle engine cabin suspension on both ends of the tower, is mainly used for reinforcing the vehicle engine cabin overall connection intensity, rigidity structure balance both side vehicle cabin pressure, reduce vehicle corners tilt, improve vehicle high speed driving and bend control stability! Also improve negative pressure shock phenomenon of excessive, prolong the service life of the suspension.

Before installing the top rightPlease, vehicles parked on the flat ground, and then the left and right sides of the shock tower base fixing screw loosening sleeve rod with screw lock!

 

2After the top bar installation:

 After the top of it, the design of the vehicle tail box inside, then the top bar are respectively connected with the left and right sides of the rear suspension at the top of the fixed seat, mainly used for reinforcement of whole vehicle tail connecting structure stiffness and strength, balance the rear of the vehicle on both sides of shock pressure, reduce vehicle tilt, improve vehicle handling stability and driving speed curve is effectively improved after the shock! The phenomenon of excessive negative pressure, prolong the service life of the shock absorber!

When the top bar , needs to be parked on a flat road, and then open the tail box cover, then to the left and right sides of the interior panels apart, see the left and right sides of the suspension after the quake, then left and right sides of the head of the screw loosen shock and then cut out crossing in plaque corresponding position, connect the top after it through the plaque in the rear suspension fixed screw on the top of the tower, and then fixed lock! Finally install the plaque reduction can!

3Install the front and bottom wells:

Before the installation under the I-shaped rack will need to raise the vehicle, Then on the chassis of the vehicle before the rear beam, the lower arm of the fixed base will loosen the screw, then the chassis shell out corresponding screw holes, the supporting screw into the hole in the back card, and then set on the I-shaped rack fixed lock can!

5: after the anti-roll bar A installation:

6B: after the anti-roll bar installation:

afterThe design of B drop-down bar at the rear vehicle chassis, pull rod are respectively connected with the rear left and right sides of the lower arm is fixed on the screw base, mainly for the strengthened beams under the arm base structure of rigid connection strength, improve the stability of vehicle driving control.

When installed, the need to increase the vehicle And then on the back rest, screw loosening the hem back rest arm fixed base, fixed lock lever can complete set!

BackAnti-roll bar C segment after design is located in the vehicle chassis, tie rod respectively connected to the tail tank base fixed on the screw, it is mainly used for reinforcement structure strength of rigid tank tail dangling position, enhanced driving control stability!

When installing anti-roll bar after C vehicles need to riseThen, on the chassis of the vehicle tail box tail, the tank on both sides of the fixed base screw loosening combined with screw rod locking can be completed! (release the base fixing screw, please use the items to the tank, to avoid sinking)