VALTEK INJECTION BOARD REPAIR KIT 4 pcs
This is the original Italian set of parts provided by the manufacturer of the injection rail for its regeneration. It allows you to improve it without having to replace it with a new one.
The prepared set allows regeneration of a single section of VALTEK type 30 injectors (1Ω, 2Ω, 3Ω), old type RAIL (1Ω, 2Ω, 3Ω), RAIL IG1 Apache.
The kit includes:
stem with rubber valve 4 pcs
spring 4 pcs
rubber sealing o-ring 4 pcs
The most common problem occurring during the operation of the aforementioned types of strips is a failure of the strip injection system, which causes the so-called "injector spill".
The cause of such a defect is usually oleate contamination or wear, which causes degradation of the rubber elements of the strip.
One of the most common signs of slat wear are:
idle at idle
power drop
increase in gas consumption
problems with system adjustment
Then the simplest and cheapest solution is its regeneration, through the use of an appropriate repair set.
The set fits slats (photo 3):
Valtek type 30
Approval number: E4 67R-010104
Valtek type 30 injector is one of the most popular gas injectors. It comes in three versions of coil resistance, the most popular 3Ω with red coils, 2Ω with gray coils and 1Ω with yellow coils. At the same time, it also appears as a version with four, three, two or a single injection section.
-------------------------------------------------- --------------
Old type IG1 Rail
Approval number: E8 67R-014303
The RAIL IG1 injector is the equivalent of the most popular Valtek injector, unlike Valtek strips, it had black or blue coils in 3 Ω models, in 1 Ω models the coils were yellow as well as in Valtek models. He often had a silver body, not a black one.