0 Piece,Product Price: US $ 0
Quantity(Piece/Pieces) | 1 ~ 1000 | >1000 |
Est. Time(days) | 7 | To be negotiated |
If you finish the payment today, your order will ship out within the delivery date.
Our Factory can produce many kinds of Auto Air Conditioning AC Compressor Clutch Hub/Plate,
Clutch Coil, Compressor Clutch, Control Valve, Resistor, Tools etc. with Good Quality and One Year Quality Warrantee.
If you are a wholesaler, please feel free to contact us. Our company offer retail and wholesale service. More quantities, more compatitive prices are offered.
Specification:
INTL-XG111
Car air conditioner manual intubation tool/ AUTO AC PIPE CASING TOOL FOR REFRIGERATION HOSE AND FITTING For hose and fittings size: 6# 8# 10# 12# No
Parts Name Push-pull quick clamp
Hexagon socket bolt
Moving chuck
Large base
Push-pull quick clamp
Small base
Hexagon socket bolt
Moving chuck
Hose clamp
Fitting clamp
1 Installation and debugging:
1. Install the No. 6 small base according to the corresponding position of the No. 4 large base as shown in the figure;
2. Place two pieces of No. 9 hose clamps opposite each other, the same arc should be placed correspondingly. Specifications: 6# 8# 10# 12#;
3. Place the corresponding No. 10 fitting clamp correctly, and place it after actual comparison;
4. Adjust the tightness by adjusting the No. 2 and No. 7 bolts; each of the large base and the small base has an adjusting bolt;
Product instructions steps:
1. Tighten the air conditioner hoses of different specifications through No. 5 push-pull quick clamp, the tightness can be adjusted by No. 7 bolts, at the same time reserve enough length of air conditioning hose at the end of No 3 moving chuck;
2. Place the air conditioner fittings on No. 3 moving chuck, and realize the locking through the adjustment of fitting clamp with different specifications;
3,Push and pull No. 1 push-pull quick clamp to insert the air conditioner fitting into the air conditioner hose;
4,Loosen No. 5 push-pull quick clamp and No. 1 push-pull quick clamp;
5,By replacing different hose clamps and different fitting clamps you can realize different models conversion of different specifications of air conditioner hoses and fittings.
Package:
Office & Showroom:
Factory &Workshop:
Basic Requirements when servicing an A/C system:
1, The Accumulator or Filter Drier should always be replaced when the Air Conditioning System is opened. For warranty Purposes buyer must show evidence of receiver/drier replacement. In some vehicles the drier comes attached to the condenser so it must replaced as well
2. A/C system must be clean and free of debris and contaminants. In most cases components can be flushed; however in some instances it may be necessary to replace the condenser or other items.
3. Orifice tube must be replaced; expansion valve must be inspected and replaced if dirty or defective.
4. Correct amount and type of oil must be used. Please refer to the OE manufacturer for this information.
5. Prior to refrigerant charging, full vacuum must be done for a minimum of 45 minutes. In humid climates or during cooler days, this time should be increased to effectively remove air and boil off moisture.
6. The Orifice Tube, if equipped, should always be replaced and the Expansion Valve, if equipped, should at least be inspected for proper operation if not replaced
7. As Air shipping limit, we put few oil before shippment, so when you get the compressor, please put out all the compressor oil, and imput R134A original oil.