High rigidity, high hardness and high strength, but the gap impact toughness. PP material can withstand the tension stress and easy to weld.
Time-varying brittle at low temperature, good chemical stability and electrical performance. Working temperature from 5 degrees to 100 degrees.
Features: low density; Heat resistance, no deformation; High stiffness; High surface strength; Good chemical stability; Non-toxic harmless;
In daily life come into contact with the PP commonly used in automobile front bumper,
This product is a PP resin as the main raw material, the solid strip extrusion products, product implementation HGB2161-62 standard of the People's Republic of China.
Product characteristics: acid, alkali, corrosion.
:Applicable to PP sheet, pipe production products. A variety of chemical equipment, general prevention Welding of corrosion machinery, etc. Repair of plastic products, automotive repair welding a wide range of uses
Physical properties: MPA tensile strength of 40 or higher
Density 1.4-1.50 g/cm
VEKA softening temperature is greater than or equal to 70
Welding Rod Scope Application:
1. Paper making industry;
2. Food and beverage light industry;
3. Waste-water industry;
4. Electronic Industry;
5. Textile industry;
6. Sport and amusement industry;
7. Medical industry;
Chemical and other industry: galvanization hardware, agricultural machine, shipping parts, mechanical parts of
low-temperature atomic energy and so on. Mostly using of its high-wear resistance, high anti-impact resistance, anti-cold resistance, self-lubrication, electric characteristic.
Welding rod Main characteristics:
1. Very high-wear resistance, seven times wear resistance than steel, four times than PTFE.
2. Very high anti-impact resistance, two times impact resistance than PC, five times than ABS.
3. Good self-lubrication, the same as PTFE, better than steel and brass appended lubricating oil.
4. Good anti-corrosion resistance, it has very stable chemicals property and can endure the corrosion of all kinds of
corrosive medium and organic solvent in certain rang of temperature and humidity.
5. Very high-inadhesion resistance, the surface of product hardly affixes other material.
6. Very high-impact resistance, ten times impact resistance than PA66, eight times than PTFE.
7. Good low temperature resistance, in liquefied nitrogen (- 196), it still has the prolongation.
few other materials can reach to this performance.
8. Non-toxic and clean property, UHMW-PE, which is the material that Food and Drug Administration (FDA) and United
States Department of Agriculture (ASDA) permit to apply in food and medicine fields
