Electric desktop sealer for cans plastic/paper cans automatic container capping machine 85mm Dried Fruit Tin Can Sealing Machine
Attention:
(1)The mold is 85mm, if you want to seal other size of cans, please contact us before place an order.
(2)Buyer is responsible to unload and bring the shipment inside their location.
Lift gate/inside delivery service is available upon requested for additional fee.
(3)Your delivery address should be commercial address, should not be private residence address.
(4)We suggest you to seal plastic cans. If you want to seal tin plates, please contact us before place an order.
Introduction
The machine is suitable for all kinds of circular iron, plastic, paper cans, such as circular container seal, with reliable quality, easy operation and lighter, is an ideal equipment for food and beverage industry.
Attentions
(1)Lock all the screws and nuts before use, keep the clean about work plate and each part.
(2)Pour lubricating oil into each working part especially the lift table and the gear.
(3)If exceptional situations, check and troubleshooting.
(This product has been tested and proved to be qualified for delivery in conformity with standard.)
Parameters
(1)Productivity:10-20/min
(2)Range:φ45-126mm（1.75’’-4.91’’）
Height:39-200mm(1.52’’-7.8’’)
(others need customized)
(3)Power:370w
(4)Dimension:750×350×520mm（Desk Type）
Weight:75KG(172Lbs)
Operations
(1)Adjusting:
1)Top mould, lower mould and tools should be prepared.
2)Loosen the nut between the top pressure head and base plate.
3)Replacing the top mould and lower mould respectively.
(2)Adjusting height of the can, turn off the on-off of top mould and lift, lift the lower mould by inching to the position that hob touch the top mould. Loosen the nut on adjusting screw rod and adjust the height according to the can, put a can with cover to adjust the top mould touch it just then rotate the screw rod to lift the can 2-3mm to let cover keep sealing and rotating then lock the nut.
(3)Adjusting hobs, don't make the hobs touch the top mould when adjusting or damage them. From left to right, rotate the can shaft by inching to make the highest point of left can toward the bearing of hob. Then adjust the distance between left hob and top mould about 2mm and ensure the distance between the upper edge of hob and top mould about 0.5-0.8mm that vary based on the thickness of the plastic can. After that, lock the nuts on base plate. The left hob effect the roll rim and the right hob effect shaper. The method of right hob adjusting is the same as left hob, only the distance between the upper edge of hob and top mould about 1.0-1.5mm.
Item Include:
1 Pc of 110V/220V Auto Can Sealer, Introduction, few wrenches and fittings
Sign in 
