Notice:
When the parcel arrived to your customs,please pay the tax and pick up the parcel,
we are not responsible for any customs duty or import tax.
if your place is remote,then need to pay 38usd.
Specification:
Name: High-speed dispersion homogenizer
Optional: FJ200 / FJ200-SH
Voltage: 110V / 220V
Output power: 200W
Input power: 280W
Capacity: 30-1500ML
Speed range: 300-23000r / min
Working head configuration: ∅12mm, middle ∅18mm
Working method: intermittent
Rated torque：83 N. cm( FJ200 ) ,83 N. cm ( FJ200-SH)
Please note: 110V voltage is 220V machine add voltage transformer.
Picture show :
Securing clip
Flexible fixing clip, height can be adjusted freely according to user's specific situation.
Stainless steel column
Each product is equipped with stainless steel posts, which are not easy to rust, durable and easy to clean
Aluminum metal case
Ensure long-term mechanical accuracy to the used , continuous electrical performance , stable operation and low noise .
Machine forbid continuous used
Never leave the work head out of liquid medium and then start the machine.
Copper coil motor
Copper wire has less resistance and stronger conductivity than aluminum wire. At the same time, copper wire has lower heat generation, longer life, and reduced energy loss, so that the power of the motor is continuously output.
Decentralized homogeneous working head：
Made of stainless steel, it is not easy to corrode, high mixing efficiency,
and many models to meet the different needs of the laboratory.
Standard sent:12G and 18G
12G Working head Parameter：
Capacity ml:30-800(H2O)
Suitable viscosity: 1000 mpa.s
Rotor linear speed : 11 s/m
Invasive liquid height: 25 mm /85mm
Stator diameter mm: ∅ 12
Working head length: 150mm
Operating temperature: 120°C
Working head material: SS304
Working head bearing material: PTEE
18G Working head Parameter：
Capacity ml:50-1500(H2O)
Suitable viscosity: 2000 mpa.s
Rotor linear speed : 15 s/m
Invasive liquid height: 30 mm /120mm
Stator diameter mm: ∅ 18
Working head length: 190mm
Operating temperature: 120°C
Working head material: SS304
Working head bearing material: PTEE
Disassembly and installation steps of working head:
Please protect the work head with your hands during installation
① Press the connector fixing ring with the fingers of the other hand
② Put the driving pin
③ Align the drive slot on the drive host
④Insert and rotate the working head
⑤ Connector positioning groove
⑥ Align the anti-rotation pin on the drive host
⑦ Then loosen the connector fixing ring with your finger, the fixing ring will reset automatically, and the work head is installed. When disassembling, please protect the working head with your hands, press the connector fixing ring into place, and the working head as a whole can be removed with a little force. However, do not use too much force, so that the head of the working head hits the base plate, causing deformation and damage.
Reminder: The above dimensions are manually measured.
IF have exist data deviation，please understanding ,thanks!
25 / 85mm
