Introduction:
This machine is a special precision equipment for dental use, using laser positioning,
to ensure that the pinhole pinhole accurate. The machine uses a carbide step drill bit, and the drilling
depth can be adjusted.
2. Performance indicators:
Power supply: 220V / 50Hz, 100W (110V / 60Hz, 100W)
Speed: 5500 rev / min
Dimensions: 160 * 160 * 330mm
* Product use:
Plug in a good grounding AC 220V power supply, turn on the power switch power indicator light, while the
red laser dot light (φ1 ~ φ1.5). Just adjust the required drilling depth, put the gypsum model can be drilling.
Special note: When the gypsum model put the table laser to identify the hole, be sure to hands together with
the work of the gypsum model together, while pressing down until the drilling is completed, and then
together on the reset. Midway must not let go, or easy to break the drill bit or hole is not allowed and too large.
*. How to replace the laser head:
Unplug the power plug, open the bottom cover; loosen the laser head pin screw, pull out the laser head,
be careful not to pull the back of the wire (the other hand in the inside line); cut connected to the laser
head behind the wire, wire For the red, white and white, white line than the red line cut 20mm,
respectively, into the heat shrink tube and the new laser head red and white two lines color welding,
and then heat shrink tube (hair dryer or open fire can) make it Shrink the package can be tight; in front
of the line, behind the cable, the laser head into the hole vertically, tighten the pin screw; power on the
light, if subtle deviation, the table can be removed, and then four motor fixed Loosen the screws
(do not twist off), adjust the center and then tighten the screws.
V. How to replace the drill bit:
Turn off the power and remove the rubber cartridge. With a high wrench stuck the spindle root flat
mouth, low wrench stuck chuck shell flat mouth, loosen the thread can replace the drill, proofreading
depth with two wrenches can be tightened.
Sign in 
