E40 UV LED Light Bulbs stage lighting effect 400W Disco Party Light High Pressure Ultraviolet Fluorescent Lamp Bulb 110V /220V

E40 UV LED Light Bulbs stage lighting effect 400W Disco Party Light High Pressure Ultraviolet Fluorescent Lamp Bulb 110V /220V

parameter:
 

Voltage: 110V/220V (110V and 220V lamps can be used, but the lamps must be 400W)

Lighting power: 400W

Wavelength: 365nm

Normal life: 2000 hours

Base connector (lamp type): E40

Weight (single): 0.35KG

Size (single): length 31CM* width 13CM* height 13CM

This bulb needs to be installed on a special lamp with a 400W ballast. It can not be used directly on the lamp cap.

All bulbs have been tested and shipped, please rest assured to buy.

The bulb is a lossy item, there is no warranty period, and the mind is afraid to shoot.

Mainly applicable to:

1. Fluorescent agent developing lamp, testing financial card, credit card, banknote, check, ID card, driver's license, passport, and authenticity of valuable securities;

2. Testing in food, textile industry, archaeology, criminology, philately, darkroom, metallurgy, chemistry and medical, fluorescence testing and analysis;
3. Stage, night club, theater and signal lighting

If you receive the product, there is a sound inside,

The wavelength of this product is 365nm and can be used for various detections such as fluorescence detection and flaw detection. Ultraviolet radiation intensity according to

It is stipulated that the test should be above 3000uw/cm2 at a distance of 38cm, and the maximum can reach 8000uw/cm2, which is more than double the original standard requirement, and overcome the phenomenon of white light leakage. Through process technology improvement, even if the bulb is overheated, or When it is broken by splashing water, the bulb will not have a strong explosion that endangers safety. Users can be assured.

Please observe the following precautions when using the lamp:

1. This bulb is made of special glass with 3650A ° ultraviolet light. This glass is easier to break than ordinary glass, so it must be handled gently during transportation and installation.

2. The bulb must be installed correctly on a line with a 400W ballast in series.

3. It takes about 5 minutes after the power is turned on, and the ultraviolet radiation intensity can reach the state of stable illumination.

4. After the bulb is turned off after a period of use, if it needs to be used again, it needs to stay for about 15 minutes before the second opening. After the bulb is cooled down and then turned on, it can be used.

5. Prevent strong vibration of the bulb and splash water and other liquids on the bulb during use to prevent the bulb from rupturing.