433 MHz rf Remote Control Switch AC 220V 10A 1CH Relay Receiver for universal 500m Light/LED/Fanner/Signal transmission control

  Wiring Diagram   

Momentary Mode:

1. Press and hold one button, relay will turn on;

2. Release the button, this relay will turn off.

Toggle Mode:

1. Press button "A", relay will turn on;

2. Press button "A" again, this relay will turn off.

Latched mode:

1. Press button "A", relay will turn on;

2. Press button "B", this relay will turn off.

Delete the existing data about operating modes

Press the learning button (on the Receiver) 8 times. The existing data will be deleted succeed.

Note:

1. When you receive our products, it may set in one remote mode randomly, that because each product was tested before it can be arranged to shipment. So, please delete the existing data to first use.

2. After deleted the data, all the remote controls cannot work any more.

1. Press the learning button(on the Receiver) once. Wait for 3 seconds;

2. Press one button on the remote control. Wait for 3 seconds. Succeed.

Set up(Toggle)

1. Press the learning button(on the Receiver) twice. Wait for 3 seconds;

2. Press one button on the remote control. Wait for 3 seconds. Succeed.

Set up(Latched)

1. Press the learning button(on the Receiver) triple. Wait for 3 seconds;

2. Press button "A" on the remote control. Wait for 3 seconds.

3. Press button "B" on the remote control. Wait for 3 seconds. Succeed.

Note:

Delete the existing data before you want to change the operating mode of one remote control.