-
4 x 23HS8430 stepper motor 270 Oz-in ,76mm length,3.0A
-
1 x STB4100 V2.1 Card
-
4 x TB6600 Single axis driver board
-
1 x 350W 24V Power Supply
-
1 x English user manual
1)23HS8430 Stepper Motor
General Specification:
Step angle accuracy: ±5%(full step,not load)
Resistance accuracy: ±10%
Inductance accuracy: ±20%
Temperature rise: 80deg Max(rated current,2 phase on)
Ambient temperature ----------—20deg ~+50deg
Insulation resistance:100MΩ Min,500VDC
Insultion Strength--------500VAC for one minute
Datasheet(23HS8430,8mm diameter shaft,270 oz-in or 18kg.cm holding torque):
|
|
|
|
|
|
|
|
|
|
|
Note:We can manufacture products according to customer's requirements.
|
2)TB6600 Driver board
Feature:
1. The output current is steplessly adjustable to meet your various application
requirements.
2. Automatic half-flow function. It is also equipped with an automatic half-flow switch,
which is easy to use.
3. Use 6N137 high-speed optical lotus to ensure high speed without losing step.
4. The subdivision setting instructions are printed on the back of the board.
5. Adopt enlarged radiator, good heat dissipation.
6. With output short-circuit protection function, worry-free use.
7. Adopting the common anode input mode, there are two input terminals, the wiring is more
convenient.
Parameters:
1. The working voltage is DC 10V-45V. It is recommended to use switching power supply DC32V
for power supply.
2. Adopt 6N137 high-speed optical lotus root to ensure high speed without losing step.
3. Using Toshiba's new high-current, high-voltage TB6600HG brand new original chip, with
low-voltage shutdown, overheating shutdown and over-current protection circuits, and
short-circuit protection added compared to TB6560.
4. The rated maximum output reaches: ±4.5A.
5. Suitable for 42, 57, 86 two-phase/four-phase/four-wire/six-wire stepper motors within
4.2A.
6. Automatic half-flow function.
7. Subdivision: full step, half step, 1/4 step, 1/8 step, 1/16 step, maximum 16
subdivisions.
Note:
1. The power supply cannot be connected reversely, otherwise the chip will be burnt out.
2. The set current should not exceed the rated current of the motor.
3)STB4100 V2.1 Card
Features: 1. Support for 4-axis linkage, you can connect four stepper motor drives or servo drives; 2. Maximum step-pulse frequency is 100KHz,which is suitable for the servo or stepping motor; 3. 4 general-purpose opto-couplers isolation input : can connect the limit switch, emergency stop switch, auto tool zero, home switch etc. 4. Support for connecting electronic handwheel; 5. Have 0-10V signal output , you can use mach3 software to control the spindle motor speed. 6. 4 general-purpose isolated relay drive output interface, can drive four relays for controlling the spindle starts, forward rotating and reverse rotating, pumps or other device; 7. 1 status LED, indicate connection status on the board.
4)350W 24V Power Supply