Operation
1.Connect to the power and turn on the switch. 220v-50Hz, Please use the single-phase three socket, the outlet should be a reliable ground protection.
2. Push on the power switch“10", power indicator "11”shine means power on.
3. Pressing heating switch“12”, waiting 10 min to heating. No need to turn off the heating switch, which is automatic temperature controller.
4. First put a small amount of raw materials for pressing, to test whether the machine can be normal operation. Put the material in the hopper“2", fine tuning the Trim hand wheel“3" ,Clockwise turning hand wheel to not move, rotating around 360°.
5. Press start start press button“15", if any abnormal press“14”. If any foreign body enter the pressing chamber, stop the machine and press Reversion button“13*，when foreign body out of machine then continue pressing.
6. Press the button “12”when materials pressing finished. And let the machine working empty for 3- 5 minutes. turn off“12" and“14”.
Attion
1.Operators must uderstand the technique and performance of oil press that can operate independently
2 .Prohibited metal or other hard objects into the pressing
Chamber. Do not use the metal bar into Feed inlet.
3.When pressing sctew shaft jammed, not troubleshooting ,prohibit
forced to start, to avoid damage to parts and other accidents.
4.The oil cake should cool below 40 deg.so that can be stacked and packaged to prevent spontaneous combustion
5. Prohibit use high-power motors to drive the oil press
6 .While the machine is working, the operator shall not leave.
Disassemble
1. Press the reverse button to make the machine swivel back for 30 seconds so that the pressing frame and rod can be easily separated.
2. Do remember to put on glove to disassemble the pressing frame when the extraction is just finished. Or let the machine cool down for a while and then disassemble.
3. Take out the pressing screw and chamber.
Common problem and solution
I. If any foreign body enter the pressing chamber.
Stop the machine and press Reversion button,when foreign body out of machine then cleaning the chamber and screw, continue pressing.
2. Screw cannot take out from chamber.
Put it to the machine and let the machine idle away 5 minutes.
3. Power off above 30 minutes.
Stop add material, turn off power and plug. Clear the the hopper When power on,continue pressing after heating about 20 minutes.if the oil press machine still can not working normally,the pls get out the chamber and screw .after clear them Start to press gain.
