KuWfi High Power Wireless Router 3000mW WiFi Signal Booster 2.4Ghz 35dBm WiFi Signal Amplifier
Product Features & Description
KuWfi Wi-Fi Signal Boosters are designed for use in mobile and/or mesh wireless networking applications. It is the most consistent signal amplification available for Wi-Fi networks. Designed for bi-directional signal amplification, In contrast, traditional analog amplifier technologies can go into saturation or reduce transmit power as input signal fluctuates, negatively impacting signal quality and network performance. While allowing for the use of virtually any 2,4GHz antenna that implements an SMA-Male connector. Also the small footprint and low profile design makes it an ideal solution for mounting on vehicles or in other space constrained applications.
KuWfi 2.4 Inline Signal Booster efficiently increases signal range of any antenna by up to 200%-400% while maintaining high data throughput rates. This signal boosting functionality adds up to 16dB of transmit gain and 12dB of receive gain, resulting in a farther reaching signal and better connectivity with client radios. Results may vary depending on environmental factors, interference, cable length and type, etc.
The WiFi booster indicates which connector is for antenna and which one for the radio. There are several kind of radios that you can connect to the booster to increase the power and distance of use. For example router, access point, radio control remotes, radio control planes, drones, cars... IP camera, Walkie Talkies, etc. Always checking that the range of frequency between the radio and the booster, is the same.
Technical Specifications
Operating Range:2.4~2.5 GHz
Operating Mode:Bi-directional, half-duplex, time division duplex senses RF,
carrier from transmitter and automatically switch receiving
to transmitting mode.
Connector Type:SMA Receptacle 50ohm,To radio SMA female(hole inside),To antenna RP-SMA female(pin inside)
Input Power:0~20 dBm
Transmit Gain:15-18dB
Output Power:3000mW (35dBm)
Receiver Gain:≤ 12 dB
Noise Figure:≤3.5 dB typical
Support Standard: IEEE 802.11/b/g/n
Frequency Response:±1dB over operating range
Supported voltages: 5V~16V/2A DC
Operating Temperature:-20°C to + 70°C
Operating Humidity:Up to 75% relative humidity
Material:Cast Aluminum
Booster Size:7.3 x 4 x 1cm
Package Size:110 x 80 x 46cm
RC LRS 2.4Ghz 35dBm 3000mW Radio WiFi Signal Booster Amplifiers Signal Extend Range for FPV Quadcopter
Packing:
• 1 * WiFi Signal Amplifiers
• 1 * RG141 20cm Connecting line
• 1 * DC 2.5” to 12V 5.5”Connecting line
• 1 * DC 2.5” to USB Connecting line
• 1 * DC 2.5” to JST Connecting line
• 1 * Magic stick
• 1 * Manual
