Tiger Totem hood scratch decorative stickers head cover stickers bonnet stickers tiger head car stickers car door stickers
Features:
1、100% brand new and high quality
2、Material: special material, high temperature resistance, waterproof sunscreen, no fading, no damage to paint
3、Universal, suit for the most car
Tips:
1、Never put the car under the hot sun within 48 hours after the installation!
2、Never wash the car within 48 hours after installation!
Method 1: Dry paste method
Suitable range: motorcycle stickers or small stickers.
Use tools: clean rags, scrapers, credit cards.
1. Clean the paste position of the body. If necessary, use a cloth without fiber to remove it with 50% alcohol or isopropyl alcohol or acetone.
Soap water can also be used. The solvent-cleaned surface needs to be completely evaporated before the solvent can be used for pasting.
2. Lift the transfer film (transparent adhesive film stuck on the reflective sticker) together with the car sticker; under normal circumstances, slowly paste the side and work side by side.
With a flat, one side of the bottom paper.
3. If the length and width of the car stickers are less than 10 cm, you can also peel off the transparent transfer film and stickers. But be careful not to accidentally stick
Even or fall off the ground to get dust.
4. Use a clean rag or scraper [such as a calling card or credit card] to rub or scrape repeatedly on the transfer film until there is no bubble in the sticker.
After peeling off the [transparent] transfer film; it is recommended not to expose to the sun or wash the car within 24 hours.
Method 2: Wet paste method
Suitable range: car stickers or large car stickers.
Use tools: watering can, clean rag, scraper, utility knife, air duct. It is recommended to operate more than 2 people.
1. After cleaning the body, spray water on the body part to be attached (to reduce the viscosity of the sticker and adjust the position).
2. After determining the position to be attached, transfer the film (transparent film stuck on the car sticker) with the car sticker from right to left [or from top to bottom]
Lift one side and press it on the car with a rag, then stick it with a rag and lift the bottom paper.
3. In case of door handles or anti-collision strips, the material should be cut and wrapped or cut off according to the situation.
4. Adjust in time, after the general position of the figure is determined, use the scraper to repeatedly scrape off the water and air bubbles. When using the scraper, scrape from right to left;
After peeling off the transparent transfer film.
5. In the case of the door and the seam, use the utility knife to divide it and spread it inward.
6, try to make the water in the car stickers dry, conditional heating can be moderately heated with a hairdryer. Recommendation: Try not to expose to the sun within 24 hours, 48 ??hours It is not advisable to wash the car inside.