Introduction:
Add encoder, the chip built-in encoder, the signal has been a little wave processed, the accuracy of 400 pulsesper second.
A plurality of photoelectric sensors built, can be output Standard square wave, can be directly connect with microcontroller or PLC board, determine the motor reversing, speed control, stroke position control, synchronous operation paired synchronization and batch functions.
If you are familiar with the microcontroller or PLC board, this actuator will be perfect!!! If not, it is just a normal actuator.
Connection methods:
Red Line: DC7V- 24V power input, needs a stable and less interference DC power supply;
Green line: pulse output, high level equal to the input voltage, low 0V, the standard square wave;
White line: pulse output, high level equal to the input voltage, low 0V, the standard square wave;
Black wire: negative pole of power supply;
The following conditions can cause serious damage to the product:
1. Direct connect with AC power
2. Use in the above standard voltage environment
3. Push/Pull exceed the maximum value of the product show
4. The stroke did not finish, still with power, forced to cease
The following conditions may shorten the product life:
1. High frequency operation
2. The high temperature
Common Fault Analysis:
1. Problem: thrust didn’t reach standard value
Reason: the power is no enough
Suggestion: replaced by a more powerful power supply
2. Problem: sometime working well but sometime not
Reason: poor contact
Suggestion: replaced by a new connector
