Features:
Wear-resistant, recyclable.
Balance tiles in the same horizontal position.
Improve the installation speed of tile.
Reduce the fatigue/pressure of installers.
There is hardly any crackless, flat surface.
It reduces the need for grinding and polishing.
Prevent tiles from moving during solidification.
Specifications:
Material: High quality PP + stainless steel
Scope of application: masonry
Applicable Brick Gap: 2-6mm/0.08-0.24"
Applicable Tile Thickness: 3-16mm/0.12-0.63"
Size: 86*30*20mm/3.39*1.18*0.79"
Use Tips:
Lay the first tile, leaving more than 2mm (with cross gaskets). Close to tile.
Insert T-pins along the gap between tiles.
Then rotate 180 degrees and the T-needle is stuck at the bottom of the two tiles.
Adjust the lid with a hand/special wrench until the two tiles are on the same level.
After leveling for about 5-6 hours, before the cement/adhesive is completely dried, rotate the lid in reverse and take out the 180 degree T needle until the word is removed.
Avoid not removing the T-tile leveling system:
1. Ceramic tile gaskets are 2mm or more (cross gaskets are recommended)
2. When leveling, the cement or tile adhesives around T-type leveller must be cleaned.
3. Remove the T-type straightener about 5-6 hours after leveling before the tile binder or cement is completely dried.